Fluid mechanics MCQ-07

Q.1 Gas is a ______ fluid. 
A. Compressible 
B. Non - compressible 
C. Viscous 
D. Non- viscous 
Ans-: A

Q.2 The ratio of the mass of a body to the mass of an equal volume of a substance taken as a standard known as ___.
A. Kinematic viscosity 
B. Relative density 
C. Density
D. Viscosity 
Ans-:B

Q.3 The rise or fall of a liquid in a capillary tube caused by the surface tension called ?
A. Rise of liquid 
B. Fall of liquid 
C. Capillarity 
D. A+B
Ans-: C

Q.4 The fluid such as air for which the density is not a single-valued function of the pressure is known as ?
A. Barotropic fluid 
B. Nonbarotropic fluid 
C. Real fluid 
D. Perfect fluid 
Ans-:B

Q.5 Buoyant force is equal to _____.
A. Force exerted by body
B. Volume of liquid displaced 
C. Force exerted in body
D. Weight of the body 
Ans-: B

Q.6 Stanton tube is used to measure which of the following?
A. Shear strain
B. Shear stress in fluid 
C. Shear strain in fluid 
D. Pressure of fluid 
Ans-: B

Q.7 What is the density of air ?
A. 11.2 kg/m^-3
B. 1.24 kg/m^3
C. 1.24 kg/m^-3
D.  12.4 kg/m^3
Ans-: C

Q.8 Whether stream function exists for which type of flow?
A. Uniform flow 
B. One dimensional flow 
C. Turbulent flow 
D. Two dimensional flow 
Ans-: D

Q.9 What is the value of density of mercury?
A. 1360 kg/m^-3
B. 13600 kg/m ^-3
C. 14000 kg/m^3
D. 13560 kg/m^-3
Ans-: B

Q.10 The square root of ratio inertia force to gravity force is called ?
A. Real number
B. Froude number
C. Reynolds number 
D. None of these 
Ans-: B

Q.11 When specific mass flow is not able to take place in a pipe line us called ?
A. More pressure in pipe line 
B. Choking in pipe line 
C. Disturbance in flow
D  None of these 
Ans-: B

Q.12 Maning's formula is used to measure?
A. Viscosity of fluid
B. Velocity if fluid in pipe 
C. Pressure of fluid in a pipe 
D. Surface tension 
Ans-: B

Q.13 Velocity potential is which type of quantity.
A. Dimensional
B. Scalar
C. Non - scalar
D. None of the above 
Ans-: B

Q.14 In open channel maximum velocity occurs at ______.
A. Center of the channel 
B. Top of the channel
C. Near Bottom of the channel 
D. First point of the channel 
Ans-: C

Q.15 Velocity is zero at which point ?
A. Stagnation point 
B. Triple point 
C. Critical point
D. None of the above 
Ans-: A




No comments:

Post a Comment

I.C ENGINE MCQ

Q.1 The air standard efficiency of an Otto cycle compared to diesel cycle for the given compression ratio is____. A. More B. Less C. Same D....